Announcement

Collapse
No announcement yet.

08 X-35 ballast help

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • 08 X-35 ballast help

    I purchased a set up from wakemakers for my x-35 a few weeks ago. I installed everything this weekend and decided to take the boat out today for a test run. My system runs off my factory pumps and hard tanks. Once the hard tanks are full it over flows into the ballast bags. So here lies my problem once my hard tanks are full my pumps shut off. Is there away to bypass this? Or a fix for the pumps shutting off? And help would be greatly appreciated. I searched x-35's but there wasn't much info out there.

    Josh.

  • #2
    Well after about another hour of searching the forms I found a post on timers. I'm guessing the x-35 has the same set up and you need to reprogram them. Sorry for cluttering the forms with another post on pumps shutting off.

    Josh.

    Comment


    • #3
      Josh, there is user here that has the hardware and will reprogram your timers. Sorry, I don't have the message bookmark, but it is in this sub forum.

      Found it: http://www.mastercraft.com/teamtalk/...ad.php?t=50038
      Last edited by CantRepeat; 12-05-2012, 06:57 AM.
      Tim
      Gone, surfing.

      Comment


      • #4
        '08 should have 20 min timers, here is the procedure.
        Attached Files

        Comment


        • #5
          Originally posted by CantRepeat View Post
          Josh, there is user here that has the hardware and will reprogram your timers. Sorry, I don't have the message bookmark, but it is in this sub forum.

          Found it: http://www.mastercraft.com/teamtalk/...ad.php?t=50038
          this is the route i went with on my 07 timers. great service!!!

          Comment


          • #6
            Originally posted by ttu View Post
            this is the route i went with on my 07 timers. great service!!!
            Thanks!
            '07 Navy Blue X2 MCX
            http://www.wakeblaster.com/

            Comment


            • #7
              Thanks everyone for the help. I'm going to pull mine out and send them out to Tr6coug.

              Comment

              Working...
              X