|
#21
02-23-2021, 10:36 AM
|
|||
|
|||
|
I have done two UFP conversions - ‘06 and ‘15 MC trailers.
The simple bolt on conversion wouldn’t work for the ‘15 as it was too short and the hinge bolt spacing is different than the TDE hinge. I contacted UFP about fabricating a longer weld-on but that’s a no-go for them without involving engineering. In that situation I had to cut off the TDE actuator and weld the UFP in its place, leaving the hinge. Once it was painted up you can’t even tell it’s been modified. 
|
|
#22
02-25-2021, 03:53 AM
|
|||
|
|||
|
Pacific Trailer in Chino, CA has contact with UPF for a conversion, but due to COVID there is a backorder right now. Supposedly its a bolt on and they just need to know if the actuator is a 4 or 5 inch for each trailer. Try them if you like.
|
|
#23
02-25-2021, 10:13 AM
|
||||
|
||||
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
