Any Interest? Boat Lift MN

[RMEngdahl]

Considering a new lift, putting out some feelers for ours.

#3600 vertical lift made by Vibo
110v lift assist motor
Has rear guides that are not pictured.
Located: Nisswa, MN

Anyone interested??




Sent from my iPhone using Tapatalk

[Shamrocker44]

Interested

What are you looking to get for it? I have an 05 197 and am located just over the river in Chippewa Falls WI.
Have been shopping Shoremaster to match our Pontoon lift and was going to order next month for spring of 21.
Does it have a canopy?

[RMEngdahl]

What are you looking to get for it? I have an 05 197 and am located just over the river in Chippewa Falls WI.
Have been shopping Shoremaster to match our Pontoon lift and was going to order next month for spring of 21.
Does it have a canopy?

No canopy. Haven’t looked too hard for comps yet but was thinking maybe around $2500.


Sent from my iPhone using Tapatalk

[mustangtexas]

Do you mind giving me a measurement of the space between the bunks and if they are not parallel the measurement at the bow end and the stern end. Thanks in advance.

[RMEngdahl]

Do you mind giving me a measurement of the space between the bunks and if they are not parallel the measurement at the bow end and the stern end. Thanks in advance.

It will be a week before I’m back there. They are relatively adjustable. I think I have the back at near 36” on center. I measured the front bunks on the trailer to find the front spacing and spaced out the back as far as I could. I think it’s 18”-20” in front.




Sent from my iPhone using Tapatalk

[mustangtexas]

Thanks. I have a lift that I picked up for our place in WI and will be using it later this summer. It was used for a MariStar but I have a 197 so needing a good starting point.