Ballast System Install

[KnoxX2]

Update to an X2 now

[gsxrjtt]

My vote take it off also .. you upgraded the boat up grade the looks hehe ..

[Footin]

do you plan on keeping the maristar stickers ?? .. you have turned her into a pretty nigh wake board / surf boat now.

Good question, I kinda like the Maristar stickers. But I guess I could call it an X2 now huh?

My daughter wants me to remove the Maristar label and either leave it blank or put on some kind of X2 sticker.

What do you all think?

[gsxrjtt]

do you plan on keeping the maristar stickers ?? .. you have turned her into a pretty nigh wake board / surf boat now.

[KnoxX2]

Yes I taped the clamps, they have those sharp edges and I did not want to cut anything (like me).

Wimp

[Footin]

Mike, I can't believe I missed this thread. Such nice work on the install from the pump mountings to the ubolts to pickup placement. I'm glade the wiring works out with the switch panel. Did you even tape/heat shrink the hose clamps?

Yes I taped the clamps, they have those sharp edges and I did not want to cut anything (like me).

[Ryan]

Mike, I can't believe I missed this thread. Such nice work on the install from the pump mountings to the ubolts to pickup placement. I'm glade the wiring works out with the switch panel. Did you even tape/heat shrink the hose clamps?

[Traxx822]

Thanks.

Sent from my HTC One using Tapatalk

[Footin]

You can use what ever connector/solder joint you want to.

[Traxx822]

I guess that's what it is for. Not sure. I didn't buy them

Sent from my HTC One using Tapatalk

[Footin]

I have a quick question if you don't mind a little derail. But do I need these connectors or can we just use shrink/solder etc?
http://www.wakemakers.com/pre-wired-...connector.html

For wiring the switch?

[Traxx822]

I have a quick question if you don't mind a little derail. But do I need these connectors or can we just use shrink/solder etc?

http://www.wakemakers.com/pre-wired-ballast-pump-switch-connector.html

[uplander]

Looks good, that is a bunch of holes you drilled

[Footin]

Oh yeah, I also have to put away what seem like every tool I own that are all over the work bench and inside the boat.

I really do not remember getting all these things out???

[Footin]

Now that I'm done turning the boat into Swiss cheese, the only things left are to route and install the vent hoses, install one of the rear panels, lay in the rear sacs and clean it up.: