07 x45 ballast flashed 3 times

[Waistline00]

07 x45, Starboard pump, worked last trip. This trip flip the switch while idling over 1500 rpm, switch lights up solid for about 5 seconds, then starts blinking 3 times. Is there somewhere I can find the codes for the switches blinks? And or if you know what 3 blinks means, what's the diagnosis/ repair?

[tr6coug]

Attached is the JABSCO's guide for the timer. 3 blinks either means low voltage detected, or connection loss between timer and pump. The TS guide says 3 blinks is bad motor/motor disconnected, but the flow chart says 3 blinks is low voltage. Its probably not low voltage since only one of the timers is showing an error.

These timers are notoriously unreliable and frustrating. I can reprogram them so they are reliable. If you ever want to do that PM me.

Reprogramming thread here:
http://www.mastercraft.com/teamtalk/...ad.php?t=50038

[Mastar]

Attached is the JABSCO's guide for the timer. 3 blinks either means low voltage detected, or connection loss between timer and pump. The TS guide says 3 blinks is bad motor/motor disconnected, but the flow chart says 3 blinks is low voltage. Its probably not low voltage since only one of the timers is showing an error.

These timers are notoriously unreliable and frustrating. I can reprogram them so they are reliable. If you ever want to do that PM me.

Reprogramming thread here:
http://www.mastercraft.com/teamtalk/...ad.php?t=50038

This is almost a necessity. well worth it. Quick turn around and has been flawless for me.

[Waistline00]

Turns out, gotta plug em back in after working on em. Easy fix.