What Work did you do on your Mastercraft Today?

[Tookeymonster]

I have been curious if anyone has used one of these drive on lifts with a V drive. How do they work with tracking fins and how do you know how far to stop? Or am I mistaken and its on bunks?

6am wash & wax on the dock. Happy Monday!

[SteveO]

Looking good!

Looking good Kent. Are you in the north or south side of the lake? I'd love to join you for early morning weekday pulls.

[FoggyNogginz]

Ha! Good catch! I had to run to a meeting and didn't have time to do the windshield or vinyl yet. Planning on that tomorrow.

[01star]

6am wash & wax on the dock. Happy Monday!

Don't forget that windshield!

[FoggyNogginz]

Much appreciated!

Sent from my SM-G781U1 using Tapatalk

[Prostar 190]

6am wash & wax on the dock. Happy Monday!

Looking good!

[FoggyNogginz]

6am wash & wax on the dock. Happy Monday!

[musicmd]

Created a Gatorstep template for my 2004 X-10. Will send that off in the morning and then will get started with Seadek in the bunks and reinstalling the new vinyl. Progress!

[tex]

Was the martini SHAKEN and not stirred? Yes, the Shake Weight of a martini shaker is work!

Always shaken...Moved onto reattaching the edges of the carpet on the floor behind my motor box!

[mike koen]

Only if you knock the glass over.

[bret]

Was the martini SHAKEN and not stirred? Yes, the Shake Weight of a martini shaker is work!

[tex]

Cap, rotor, plugs, and change oil....Does sitting in it drinking a martini count as work?

[bret]

Not my boat...PDM install as part of the restoration of a 1994 Pro Tour 190 w/LT1.





Today, I'm running new fuel line, check/clean the screen at the bottom of the fuel pump, and install new fuel filter.

[MarCraft1991]

Absolutely. Glad I could finally give YOU some information since it’s always going the other way! As with everything I make, looks good as long as you don’t look too closely, haha

[waterlogged882]

Spent some time on Amazon trying to find flip up hinges that would fit inside the cup holders and a long center leg that would also flip closed. Cut some dowels to fit down in the base of the cup holders—and that was it! Everything is flat when stored, and fits tight when I open it and put the legs in.

Here are links! (Probably won’t last long given the provenance of the sellers, if you know what I mean!)

2 pcs Stainless Steel 90 Degree... https://www.amazon.com/dp/B08BRVS92J...p_mob_ap_share

Wall Foldable Dining Table Legs,... https://www.amazon.com/dp/B07Y22BKZN...p_mob_ap_share

Thank you for the information. I am very simple but this struck me at first sight. Yours looks great.