What Work did you do on your Mastercraft Today?

[epnault]

Watched it snow on my boat.

I got one of those too.

[paintpollz]

When it comes to trailer wiring always make sure you have a great ground. That is usually the culprit.

The culprit is some **** mouse that crawled its way into the tube and munched on some wire for lunch. Now I need to replace all of the wiring.

[ncskier]

Nothing better than getting your cable greased on Friday night



Ready for some weekend skiing now ...


Sent from my iPhone using Tapatalk

[epnault]

The culprit is some **** mouse that crawled its way into the tube and munched on some wire for lunch. Now I need to replace all of the wiring.

Oh man that sucks. I hate mice

[CantRepeat]

Have you ever seen a shout out from him?

I'll give you one for sharing your knowledge here!

Let's get married and have a baby!!

[ks205]

Started piecing together a back floor section for my 205

[MattsCraft]

She's Alive!

[orbeamlb]

First wax of the season and some detailing. Now if the weather would cooperate.

[VP46]

She's Alive!

And She's got a sexy growl to boot!

[frankster1969]

Fixed an ouch that happened while pulling out the old rudder port...
Turned out pretty good :-)

[FoggyNogginz]

Today I "worked" on the boat by running a tank of gas through it. Project complete!

[david_ski]

A round of buffing compound followed with a coat of wax. Now it ready for a season at the pond.

[jpage]

got the motor in my '84 on saturday

[02ProstarSammyD]

*6-7 hours of polishing out rub marks and a few scuffs and waxing/polishing
*Sanded down teak and threw some linseed/spirits on it.
*repainted platform brackets
*cleaned interior
*Got nautic logic 100% done
*changed out winch handle
* went to the lake. Took a few surf sets to test out the new ballast and took 1 wakeboard set which ended with a binding coming dislodged and a twisted ankle. YAY for that one!

Kids were stoked to be back on the water even if they couldn't get in.

[dt37803]

Shower install

Might seem a little redneck but installed a home made shower in the X2 last week. Hot and cold 1/4 ball valves tied with a T to the pump and an extended sink sprayer for the shower head. Pump has pressure switch which gives an auto shut off when releasing handle. Still tied to a master switch for power.