What Work did you do on your Mastercraft Today?

[Bubbacuse77]

Amazing what how much dirt collects in the hidden spots

[Rockman]

I was inspired by Rockman recently. Making my way around boat. Hopefully Peter will bump my MCOCD as I got hammered for my battery cables.

Yes, but once you go through the entire boat, you can then do the day to day maintenance and it will never get like that again...PO of our 190 kept the boat "very" clean . I guess "very" clean has different meanings. But in the end, it was a fun project and now I can sleep at night.

Great job! Boat looks awesome!

[Bouyhead]

Installed a new bilge pump and switch on the 205V. Thanks Olaff!

[thatsmrmastercraft]

I was inspired by Rockman recently. Making my way around boat. Hopefully Peter will bump my MCOCD as I got hammered for my battery cables.

After photo.

Huge difference, but concerned about the roll of toilet paper on the swim platform.


Nice work

[mikeg205]

After photo.

now you've done it.. now I have to check my open bow

[mgs96ps]

......

[whisperinpete]

Nice job. This is the wye style with brushed welds that I am looking to install once I finish up the dimensions. What model did you install it on. Looks great!!

Sent from my SM-N920V using Tapatalk

2009 X2

[LKNtristar]

What Work did you do on your Mastercraft Today?

Finally got around to removing my MariStar decals to replace with the drip molded Mastercraft decals. Lots of elbow grease, but no residue whatsoever.






Sent from my iPhone using Tapatalk

[SilvrSurfr]

Very nice!!

[outdoorjp]

Finally got around to removing my MariStar decals to replace with the drip molded Mastercraft decals. Lots of elbow grease, but no residue whatsoever.






Sent from my iPhone using Tapatalk

Looks good where you get the decals?

[Dkdorsey]

Wired LED speaker rings and additional lightening throughout the boat.


Sent from my iPhone using Tapatalk

[Keith2230]

Yanking out the hacked up stereo system. Remote power wire just wrapped around another and covered up with electrical tape. For some inexplicable reason they used some outdoor lighting cable and spliced in behind one the speakers. Ground loop isolators and wire caps. Should have taken pictures of the wire mess they had zip tied up behind the stereo. Ready to start over with some new toys from Earmark!

[LKNtristar]

Looks good where you get the decals?

Great Lakes Skipper has a good selection. Went with the 51 1/2" decal for the hull and the 26" for the transom. All in was about $370 for the 3. Scoop them while you can because MC is tanking them off shelves for copyright and branding

[Breiti]

bring the MasterCraft Logo on my platform,
have to sand and oil it to finish,
can´t wait for it....

[Bubbacuse77]

Can't wait to see it sanded and finished