What Work did you do on your Mastercraft Today?

[Alistair]

I have a hydraulic filler on the right (behind the wheel on the pic) but there was no reservoir there - it's a quick check under the dash with a drinks holder to see if it would fit.



I did measure it many times before actually drilling a hole - and as I drilled the big hole from below, I was nervous as I stood up to see what it looked like from above.

The dash is quite thick, but relatively soft & easy to cut through

[thatsmrmastercraft]

I fitted some extra some extra cup holders in the dash



It was too tight for the hole cutter & drill with the windshield, so I drilled a pilot hole from the top, then used the hole cutter from underneath

Looks great. I really need to do the same. Tires and wheels holding up well?

[Breiti]

I fitted some extra some extra cup holders in the dash

I love that idea!

[Alistair]

Looks great. I really need to do the same. Tires and wheels holding up well?

Yes thanks - very happy with them

[thatsmrmastercraft]

Yes thanks - very happy with them

Great! Thanks again for your business. It is cool to have wheels all over the world.

[Skyskiguy]

I fitted some extra some extra cup holders in the dash



It was too tight for the hole cutter & drill with the windshield, so I drilled a pilot hole from the top, then used the hole cutter from underneath

I was going to do the same but the dash isn't totally flat and I wasn't sure how the lip of the cup holder would sit. Do they fit flat enough that the cup holders don't feel loose and looks ok?

[Alistair]

Mines not totally flat either - there's a slight gap at the front, but nothing much - I plan to slightly bend the lip of the holder to eliminate it.

The fit is really tight - there's zero movement in the cup holder, but I guess that's down to having the right sized hole cutter - mine is metric so might actually be slightly undersized, not sure - but I already had it so maybe got lucky.

I'll take a picture tomorrow to show as best I can

[Alistair]

Here's as bad as I could make it look - pressed fully flat at the back - so in reality, the gap is half as much.

I plan to bend the lip down slightly, just haven't gotten around to it yet.....

[Skyskiguy]

Here's as bad as I could make it look - pressed fully flat at the back - so in reality, the gap is half as much.

I plan to bend the lip down slightly, just haven't gotten around to it yet.....

Based on your success, I ordered two cup holders from waterskis.com. They will be here Monday.

[CantRepeat]

Based on your success, I ordered two cup holders from waterskis.com. They will be here Monday.

Are you doing one or both sides? I dunno, double fisting on a boat may be bad.

[CantRepeat]

Pulled it out and blew off all the tree pollen on the cover. Drained a sample of the AF and did a hydro test on it. The results should be up by tomorrow; maybe Monday if I don't get it done. I learned some things.

[Alistair]

I had only planned to do the right side - but you kind of have to keep the symmetry......

[VP46]

I had only planned to do the right side - but you kind of have to keep the symmetry......

And you never know when you have to cater to a left handed beer drinker.

[RMEngdahl]

Not sure if the previous owner ever oiled this thing.
Prepped and with new transom saver.



Sent from my iPhone using Tapatalk

[Skyskiguy]

Are you doing one or both sides? I dunno, double fisting on a boat may be bad.

I'm doing both sides.