What Work did you do on your Mastercraft Today?

[tex]

ordered a new spare tire.

[Wheeldog]

Installed and tested a new rebuilt prop! Whoa!!! I love full throttle starts!

[nickespi]

Made some new bunks for the trailer. Going on this weekend. Went with black carpeting. Should look way better than what was left of the old grey junk.

[SunCoast 83]

Waxed, waxed, and waxed. Also redid the teak.....Again. It still needs a few more coats of oil but getting close. Pics from cell so might be hard to see. The wax I used took off 99% of all oxidation. I was impressed

That looks great. Nice color combo as well....

[SunCoast 83]

Ordered new custom reg numbers from a local sign and graphic shop, for the front of the boat today. I heat gunned the old numbers off and I wish I could leave it without any numbers on it. It looks more sleek and clean, and I am all about that!

[02ProstarSammyD]

changed fuel filter, changed oil sending unit, found a broken fuel line, changed the trans fluid, changed distributor cap/rotor, put on a new trailer jack, and then shined up the tower

[gatorguy]

Tried to switch out my old 4 flat for a 7 round plug. I was trying to solder the connections, but the stupid OK wind was too strong, 27mph. The wire wouldn't get hot enough unless I took it in the garage. I'll have to wait until tomorrow when the wind dies down should only be 5MPH tomorrow. Guess I should just shut up and be glad the 210mph tornado didn't get me yesterday.

[Gabe63]

Installed PP Stargazer Wake edition and tested it out. Exceeded my expectations. Much smoother than I thought it would be.

[blakehardesty]

Finished up the teak, changed impeller, swapped to new OJ 12.5x12 XMP 4 blade

[ShamrockIV]

ordered new domed registration numbers

bought 2 400lb fatsacks to plumb in tonight!!!

[agarabaghi]

Ordered new custom reg numbers from a local sign and graphic shop, for the front of the boat today. I heat gunned the old numbers off and I wish I could leave it without any numbers on it. It looks more sleek and clean, and I am all about that!

I made it about a week with no numbers on the chain haha

[agarabaghi]

Installing JL 10" sub, LED ring for sub, wiring up sony amp to run 4 speakers and sub while i wait for the wetsounds.

It never ends!

[1redTA]

new hubs and bearings, bought a spare tire, impeller, rebuilt raw water pump myself thanks SkiDim!, thermostat, new 105 amp alt, sand blast and paint some of the brackets from the engine


pallet wrap the boat to the trailer for a 550 mile ride today, don't laugh! it cant hurt

still need to replace the packing ( nearly drillers GoreTex ) backing plates for the swim platform

[nickespi]

I replaced the rubber inserts on the board racks. Now I can fit my surfer in the stock fingers.

[CantRepeat]

I replaced the rubber inserts on the board racks. Now I can fit my surfer in the stock fingers.

Post up the pics!! What did you replace it with? What fingers do you have? What surfboard do you have?