1981 Bow vent 3D print

[1redTA]

Printing half of the rear vent (transom) with more leftover PLA. I ordered a 2kg role of black PETG to try a print with today once it shows up. The colors available have me thinking about a sand colored filament to blend/match the vents with the boat. This print will only be 12 hours…

[waterlogged882]

Printing half of the rear vent (transom) with more leftover PLA. I ordered a 2kg role of black PETG to try a print with today once it shows up. The colors available have me thinking about a sand colored filament to blend/match the vents with the boat. This print will only be 12 hours…

go ...

[1redTA]

something disrupted the print boo

[waterlogged882]

something disrupted the print boo

Go again...
.

[1redTA]

ha ha right? I’m working the next 48 and spent today getting the fence line ready to be replaced. maybe by the middle of the week

[waterlogged882]

ha ha right? I’m working the next 48 and spent today getting the fence line ready to be replaced. maybe by the middle of the week

Update?

.

[1redTA]

been dealing with Covid and quarantined in a part of the house, not in the same room as the printer :-)

now the wife has it

[1redTA]

The PETG is having issues so I am looking for better printer settings, 250 hot end, 60 bed and zero fan will be next. The carabiner I printed as a test was easily pulled apart and had bad layers that sphagettied

[waterlogged882]

The PETG is having issues so I am looking for better printer settings, 250 hot end, 60 bed and zero fan will be next. The carabiner I printed as a test was easily pulled apart and had bad layers that sphagettied

Best on the deliverable. Thanks for the update.

.