Brake actuator

[bturner2]

That's the smart move if you can do it.

[Miss Rita]

I cut my old tongue off the end of last summer and put a UFP-a60 tongue on. I also changed the brake lines and put new kodiak calipers on. Now my brakes are awesome. I also made it swing away for storing it in my garage.

^^Just do this, you'll never regret it ^^

[toddvdh]

I cut my old tongue off the end of last summer and put a UFP-a60 tongue on. I also changed the brake lines and put new kodiak calipers on. Now my brakes are awesome. I also made it swing away for storing it in my garage.

I have the reverse lockout cap but also wired in a 5 pin connector for the reverse solenoid. Now I don't have to get out to back up.

I does help that i work at a weld shop. I was done in about an hour with the cutting and welding.

[ValveCoverGasket]

Did you figure this out? My old boat had an actuator like this... I liked it much better than the one shown above due to the reverse "pinning". You pull the pin from under tongue and use it to lockout brakes for backing up.

Tie Down Engineering Brake Actuator Model 660

https://www.tiedown.com/pdf/c1250.pd...vw8h698aoawKY7

maybe it goes without saying but... the one above has a physical reverse lockout via the locking cap (optional) and comes with a reverse solenoid to lock out braking when your truck reverse lights are on.

[babymoore3]

Did you figure this out? My old boat had an actuator like this... I liked it much better than the one shown above due to the reverse "pinning". You pull the pin from under tongue and use it to lockout brakes for backing up.

Tie Down Engineering Brake Actuator Model 660

https://www.tiedown.com/pdf/c1250.pd...vw8h698aoawKY7

[mikeg205]

Yikes... this would be a step up.. but you would need a good welder to cut off what you have and add the right piece of tongue

Sent from my SM-G955U using Tapatalk

[jdevans07]

Yah, its old. Tongue on my trailer is welded. I'd love to find a replacement, which is proving to be difficult

[mikeg205]

Looks like old master cylinder. Check measurements and see .. as stated above.. the ufp products will fit.

You might need a new tongue on trailer to use new actuators

Sent from my SM-G955U using Tapatalk

[robadele]

https://www.amazon.com/UFP-Complete-.../dp/B074KKCJ26

See the link. There supposedly is a UFP actuator that fits into the Attwood mounting. I have not used it and cannot speak to how well it fits / works. UFP is the most common actuator on trailers through around 2010.

[jdevans07]

Heres a few pics

[mikeg205]

Postup a pic

Sent from my SM-G955U using Tapatalk

[jdevans07]

Hey all,

I have an '83 Mastercraft with a V/M dual axle trailer and a shot brake actuator. Its an Atwood 85736. Everything I find on the interwebz says the 85736 and its replacement 85841 are discontinued. Is there anything else that will work??