Announcement

Collapse
No announcement yet.

User Profile

Collapse

Profile Sidebar

Collapse
Avatar
jpwhit
TT Enthusiast
Last Activity: Yesterday, 09:24 PM
Joined: 07-17-2019
Location: Southeast
  •  
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • I looked at my X25 this weekend in regard to what it would be like to pull the engine / trans. The access looks quite good. I'm attaching a couple of pictures marked with a red box. The first picture shows the center section of the rear seat. That entire center section comes out with a few bolts. With...
    See more | Go to post

    Leave a comment:


  • jpwhit
    replied to NMEA 2K & Raspberry Pi - Anybody?
    Standard USB ports do provide enough power to run a Raspberry Pi.
    See more | Go to post

    Leave a comment:


  • I'm weigh 165, so not sure if this will help much, but I can easily climb into the compartments on each side of the engine. It gives good access to the sides of the engine. This is with the below the floor rear hard tanks in-place....
    See more | Go to post

    Leave a comment:


  • jpwhit
    replied to cavitation due to oversized prop
    I'm assuming you haven't tried it in the water yet. Given that you've done the work, that's what I would do next. I wonder if it'll be noisy. But other than that, I think the suggested clearance are primarily to prevent gel coat and fiberglass damage. I doubt that'll be an issue with your steel pla...
    See more | Go to post

    Leave a comment:


  • I have a 2014 X25 that I bought in slightly rough shape. I do all my own maintenance including big jobs like engine and transmission rebuilds. I haven't had to pull the engine or transmission on the X25, but overall it's not any harder to work on than any other v-drive. I've completely disassembled...
    See more | Go to post

    Leave a comment:

No activity results to display
Show More
Working...
X