Not sure about the factory board racks but the Skylon makes board racks for the ZFT2 tower.
https://www.skylonsports.com/collect...al-mastercraft...
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
-
-
Mine failed catastrophically, without any warning. It was very immediate with part debris under the engine, although the pump looked fine from what one could see. Once it cooled we felt the back of the pump and there was no back. Snapped a picture and confirmed the rear casing of the pump was missing...
Leave a comment:
-
It looks like there might be an additional new speaker option in 2023. The promo boat has 3 speakers per side as shown in the second photo. New speaker locations are next to the observer seat and the feet of the driver. The "design your boat" tool on the website only lists advanced audio and...
Leave a comment:
-
Start with the input sensitivity at the minimum level. Set the volume and zone level to about 80%, then increase the input sensitivity until you start to hear distortion, then back it off a little.
A more exact method of setting the input sensitivity can be used if you have access to a...
Leave a comment:
-
Thanks for letting me know. I cleared out some messages but it seems like the mailbox here fills up quick.
Have I responded to you about your order via other means?...
Leave a comment:
-
I need to order 4 of your Klipsch to RCA adapters for the cabin speakers. I can't remember how I ordered them last time.
Thanks!
Bryan Schumacher
-
I wonder if MC is planning on updating the transoms of the XT20, XT21, XT25 this year along with this new XT22t. It seems like a lot of traditional bows to have the XT21, XT22t, XT23 all in the traditional bow lineup with 1' of length as the only differentiator between each model.
Leave a comment:
-
Did you end up finding anyone selling 15' of wetsounds 1/0?...
Leave a comment:
-
Oh weird. In my boat (2018) the factory installed a 250A ANL fuse + holder installed next to the house battery to protect the cable....
Leave a comment:
-
I know we talked about it but if it happens again to you or someone else, you can bypass the solenoid by putting both of the big 1/0 cables on the same stud of the solenoid. Should just need a pair of pliers to bypass it....
- Likes 1
Leave a comment:
-
I think there is a "marine" edition of the hydrastar pump but long as the entire unit isn't submersed for an extended period of time I don't think there's any issue. They're made to get wet since trailers get towed in the rain or are stored outside. I haven't heard of any failures. The bigger...
Leave a comment:
-
Did the upgrade and documented it in this thread, starting with post Team MasterCraft https://teamtalk.mastercraft.com/for...22-build/page4...
Leave a comment:
No activity results to display
Show More
Leave a comment: