Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.13 seconds.
Search: Posts Made By: mikeg205
Forum: General / Other 07-15-2019, 11:51 PM
Replies: 7
Views: 160
Posted By mikeg205
41 is good for a water sports tug... decent wake...

41 is good for a water sports tug... decent wake and lower speed wake boat...

Sent from my SM-G955U using Tapatalk
Forum: Engine / Drive Train 07-14-2019, 10:59 PM
Replies: 4
Views: 117
Posted By mikeg205
Spares in the library under general discusion.....

Spares in the library under general discusion.. in the dropbox

Sent from my SM-G955U using Tapatalk
Forum: General Discussion 07-14-2019, 12:28 PM
Replies: 20
Views: 1,085
Posted By mikeg205
UFP was bought by dexter axle.. fwiw Sent from...

UFP was bought by dexter axle.. fwiw

Sent from my SM-G955U using Tapatalk
Forum: General Discussion 07-08-2019, 06:13 PM
Replies: 8
Views: 350
Posted By mikeg205
Lynn pier is good but no amenities... like a...

Lynn pier is good but no amenities... like a ghost town during week..

Sent from my SM-G955U using Tapatalk
Forum: Engine / Drive Train 07-06-2019, 04:27 PM
Replies: 7
Views: 342
Posted By mikeg205
Maybe a little too OCD.. Sent from my SM-G955U...

Maybe a little too OCD..

Sent from my SM-G955U using Tapatalk
Forum: Engine / Drive Train 07-05-2019, 03:35 PM
Replies: 5
Views: 136
Posted By mikeg205
pull the trans button... and try to start. then...

pull the trans button... and try to start. then you will know as well.
Forum: Engine / Drive Train 07-05-2019, 02:26 PM
Replies: 44
Views: 1,270
Posted By mikeg205
what about the fuel pump relay?

what about the fuel pump relay?
Forum: General Discussion 07-04-2019, 04:02 PM
Replies: 13
Views: 283
Posted By mikeg205
Screws should be glued in with 3m 5200... slow...

Screws should be glued in with 3m 5200... slow cure but will hold. Up pressure from over ballasting will stress screws loose.

Sent from my SM-G955U using Tapatalk
Forum: Engine / Drive Train 07-04-2019, 12:46 PM
Replies: 44
Views: 1,270
Posted By mikeg205
check your wiring harness, something may have...

check your wiring harness, something may have grounded out. engine has a timing chain and MCX has distributor iirc. 81 code also can point to a fuel pump bad relay. Also make sure coolant temp...
Forum: Engine / Drive Train 07-02-2019, 10:32 AM
Replies: 7
Views: 206
Posted By mikeg205
Have you check coolant temp sensor... any...

Have you check coolant temp sensor... any codes?

Sent from my SM-G955U using Tapatalk
Forum: Engine / Drive Train 06-28-2019, 03:17 PM
Replies: 8
Views: 263
Posted By mikeg205
yes mine our this way - plus I have new hoses

yes mine our this way - plus I have new hoses
Forum: General Discussion 06-28-2019, 08:03 AM
Replies: 26
Views: 800
Posted By mikeg205
No.. unfortunately get a cable brake or cruise ...

No.. unfortunately get a cable brake or cruise control like perfect pass

Sent from my SM-G955U using Tapatalk
Forum: Engine / Drive Train 06-27-2019, 07:16 PM
Replies: 7
Views: 342
Posted By mikeg205
had same problem 2 layers of hand cut gasket...

had same problem

2 layers of hand cut gasket material - 3 layers of gasket sealant and covered with flex-seal.

unfortunately you can't torque the screws too much since underside mating flange is...
Forum: Engine / Drive Train 06-25-2019, 11:10 PM
Replies: 9
Views: 269
Posted By mikeg205
My fave pic.. for arguement to fix pump or...

My fave pic.. for arguement to fix pump or replace

Sent from my SM-G955U using Tapatalk
Forum: General Discussion 06-24-2019, 10:10 PM
Replies: 8
Views: 430
Posted By mikeg205
Good plan.. this will be a methodic process Sent...

Good plan.. this will be a methodic process

Sent from my SM-G955U using Tapatalk
Forum: General Discussion 06-24-2019, 10:08 PM
Replies: 3
Views: 360
Posted By mikeg205
What r u looking for specifically... if you have...

What r u looking for specifically... if you have an lt1.. we have that info.

Sent from my SM-G955U using Tapatalk
Forum: General Discussion 06-23-2019, 10:47 PM
Replies: 12
Views: 611
Posted By mikeg205
Its possible you hot something and knocked prop...

Its possible you hot something and knocked prop out of balance.. and not bent edge. Have a pic of prop?

Sent from my SM-G955U using Tapatalk
Forum: Off Topic Discussion 06-23-2019, 08:51 PM
Replies: 20
Views: 1,986
Posted By mikeg205
Prolly medical device Sent from my SM-G955U...

Prolly medical device


Sent from my SM-G955U using Tapatalk
Forum: General Discussion 06-23-2019, 06:18 PM
Replies: 8
Views: 430
Posted By mikeg205
Do you see where its leaking? Specifically Sent...

Do you see where its leaking? Specifically

Sent from my SM-G955U using Tapatalk
Forum: Electrical 06-23-2019, 05:32 PM
Replies: 14
Views: 384
Posted By mikeg205
prolly a repower - check for ecu codes.

prolly a repower - check for ecu codes.
Forum: Electrical 06-23-2019, 02:36 PM
Replies: 14
Views: 384
Posted By mikeg205
Does fuel pump prime when you key up? Is there...

Does fuel pump prime when you key up? Is there 12v at fuel pump when you key up?



Sent from my SM-G955U using Tapatalk
Forum: Engine / Drive Train 06-22-2019, 06:50 PM
Replies: 5
Views: 326
Posted By mikeg205
Shouldnt be a danger... but prolly will get...

Shouldnt be a danger... but prolly will get worse... re build or new block

Sent from my SM-G955U using Tapatalk
Forum: Engine / Drive Train 06-22-2019, 06:48 PM
Replies: 8
Views: 263
Posted By mikeg205
Yes Sent from my SM-G955U using Tapatalk

Yes

Sent from my SM-G955U using Tapatalk
Forum: Engine / Drive Train 06-19-2019, 07:48 PM
Replies: 8
Views: 263
Posted By mikeg205
Behind up middle of tank Sent from my SM-G955U...

Behind up middle of tank

Sent from my SM-G955U using Tapatalk
Forum: Engine / Drive Train 06-19-2019, 02:54 PM
Replies: 8
Views: 263
Posted By mikeg205
my hoses are routed next to port exhoust, then...

my hoses are routed next to port exhoust, then under port side of motor
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 09:36 AM.


2018