Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.98 seconds.
Search: Posts Made By: jafo9
Forum: General Discussion 07-05-2020, 04:16 AM
Replies: 3
Views: 114
Posted By jafo9
find the fuel pump 101 thread on here. also,...

find the fuel pump 101 thread on here. also, don't forget to do the fuel filter at the bottom of the assembly when you get it out. the fuel pump you can get at auto zone, unfortunately the filter...
Forum: Electrical 06-26-2020, 08:28 AM
Replies: 8
Views: 278
Posted By jafo9
Is is all the gauges at once? If so sounds like...

Is is all the gauges at once? If so sounds like a ground issue. If it is just one gauge, then the stepper motors in them are known to go bad. You have to crack open the gauge and desolder the...
Forum: General Discussion 05-14-2020, 09:17 AM
Replies: 9
Views: 565
Posted By jafo9
the bolts on my zero flex were so seized, i had...

the bolts on my zero flex were so seized, i had to drill them out and retap some of the holes. i've been using anti-seize for the past 5 years and have never had a bolt loosen. the tower gets...
Forum: General Discussion 04-11-2020, 03:31 AM
Replies: 43
Views: 2,615
Posted By jafo9
Has anyone worked with BBVA? I applied online...

Has anyone worked with BBVA? I applied online and have gotten no real feedback. I then got an email that my application was incomplete. The email gave me absolutely no specifics as to what was...
Forum: Electrical 02-21-2020, 11:08 AM
Replies: 47
Views: 12,485
Posted By jafo9
Part of the problem with the gauge was that the...

Part of the problem with the gauge was that the needle was pointing down rather than up so i couldn't make a reference mark. the boat is winterized so i couldn't run the motor. i did power it up...
Forum: Electrical 02-17-2020, 12:36 PM
Replies: 47
Views: 12,485
Posted By jafo9
Sorry for the delay on this post. It took me a...

Sorry for the delay on this post. It took me a while to get back around to putting the gauge back together. I sourced the GM stepper motors off Amazon. Soldering it back together went a lot faster...
Forum: Electrical 01-07-2020, 04:03 PM
Replies: 47
Views: 12,485
Posted By jafo9
Here is the inside of my engine temp gauge 02...

Here is the inside of my engine temp gauge 02 X30. My plan is to replace the stepper motor as the gauge stays pegged off the scale. So I desolder the 5 connectors at the bottom peaking out behind...
Forum: Off Topic Discussion 10-19-2019, 03:32 PM
Replies: 22
Views: 1,474
Posted By jafo9
I've owned several sit downs (couches) and...

I've owned several sit downs (couches) and several stand ups. Currently have 3 stand ups and and 1 couch in the inventory. As was mentioned above, 6K including trailer won't go that far. From a...
Forum: General Discussion 08-22-2019, 08:58 PM
Replies: 34
Views: 3,048
Posted By jafo9
all three counties that surround smith lake are...

all three counties that surround smith lake are dry, therefore the lake is dry as well. any alcohol is illegal there.
Forum: Electrical 07-23-2019, 10:28 AM
Replies: 0
Views: 376
Posted By jafo9
02 X30 LTR won't turn off

I've searched and haven't found a lot of information on boats that won't turn off. Here's my problem. 02 X30 LTR, cranks fine but won't turn off. I can take the key out and pull the lanyard and it...
Forum: Audio/Stereo 04-03-2019, 09:27 AM
Replies: 5
Views: 796
Posted By jafo9
I don't think I've ever used the swivel feature,...

I don't think I've ever used the swivel feature, but I take my 8's on and off all the time. While I don't have a control for comparison, I'd like to think I am extending the life of my purchase by...
Forum: Off Topic Discussion 03-17-2019, 12:35 AM
Replies: 14
Views: 1,354
Posted By jafo9
https://www.amazon.com/Security-Chain-Company-SZ13...

https://www.amazon.com/Security-Chain-Company-SZ131-Passenger/dp/B000HZFDP0/ref=sr_1_3?keywords=tire+chains&qid=1552796993&s=gateway&sr=8-3

this is the brand/style i use on my land cruiser. ...
Forum: Off Topic Discussion 02-28-2019, 09:30 AM
Replies: 30
Views: 3,559
Posted By jafo9
While I don't see the point in dropping 200K on a...

While I don't see the point in dropping 200K on a pontoon, I have to admit, most days if I am just cruising or heading to a restaurant, I'd much rather be on my pontoon. 25ft tritoon with a 225...
Forum: General Discussion 02-28-2019, 08:58 AM
Replies: 24
Views: 2,251
Posted By jafo9
I don't know if there was a major difference in...

I don't know if there was a major difference in the 07 vs the 06 X30, but the hull should be the same. only difference I can think of off hand is that in 07 the walkway door became standard and...
Forum: General Discussion 01-07-2019, 10:31 AM
Replies: 3
Views: 697
Posted By jafo9
I have the same hull and use the BoB v5 that is...

I have the same hull and use the BoB v5 that is detailed in the surf gate thread on this site. I run 1100 lb bags in the rear and 400 in the center locker. It also really helps when I put another...
Forum: General Discussion 12-12-2018, 08:47 AM
Replies: 37
Views: 6,567
Posted By jafo9
My BIL bought a new SJ a few years ago (after the...

My BIL bought a new SJ a few years ago (after the EPA ban) and there was no mention of the "race only" designation for a new 2 stroke PWC. No issues with registration and it carries the same...
Forum: General Discussion 12-07-2018, 06:04 AM
Replies: 37
Views: 6,567
Posted By jafo9
not yet. a shortened pole supposedly really...

not yet. a shortened pole supposedly really helps get your weight forward when needed. zero degree bars will help also. I did change the grips on all the skis and that helps a good bit with...
Forum: General Discussion 12-06-2018, 08:59 AM
Replies: 37
Views: 6,567
Posted By jafo9
I wouldn't let tray size determine or limit a...

I wouldn't let tray size determine or limit a ski. while it may be important for a new rider, after you get the hang of it, it really doesn't matter. As I mentioned before, I have a 89 650SX, 04...
Forum: General Discussion 11-24-2018, 06:48 AM
Replies: 37
Views: 6,567
Posted By jafo9
i'm 6'2". my weight has ranged from 240's to 215...

i'm 6'2". my weight has ranged from 240's to 215 over the past several years I've owned stand ups. I have an 05 SXR that was a former race ski with all the goodies. An 04 SJ with...
Forum: For Sale: Boats 11-04-2018, 06:38 PM
Replies: 16
Views: 4,727
Posted By jafo9
very nice. seems like a great price.

very nice. seems like a great price.
Forum: For Sale: Boats 09-06-2018, 08:32 AM
Replies: 7
Views: 3,819
Posted By jafo9
pretty nifty install location for the wet sounds...

pretty nifty install location for the wet sounds EQ. good looking boat. glws.
Forum: Towers 08-07-2018, 02:10 PM
Replies: 0
Views: 862
Posted By jafo9
Board Rack Replacement Pull Tab?

Hi all. I'm in the process of rehabbing my bungees and I can't seem to find a source for the fabric pull tab. DIY wake has a tab/cord combo for $10 but it seems like a waste since i've already...
Forum: General Discussion 08-06-2018, 04:21 PM
Replies: 2
Views: 588
Posted By jafo9
24 is pretty good considering you got the big...

24 is pretty good considering you got the big engine. to the OP, i'd say high 20's.
Forum: General Discussion 08-06-2018, 11:39 AM
Replies: 8
Views: 1,505
Posted By jafo9
yes, you can get the hours, but you have to have...

yes, you can get the hours, but you have to have it hooked up to a computer. i'm not sure how proprietary the software is. pics would help as perfect pass typically occupied the right hand large...
Forum: For Sale: Boats 07-26-2018, 05:02 PM
Replies: 3
Views: 1,620
Posted By jafo9
very nice. would love to have that tower and...

very nice. would love to have that tower and swivel racks on mine.
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 03:43 AM.


2020