$64 for a nylon drain plug?...

Intermittent problems are hard to diagnose when it only shows up once in a while. It needs fuel and spark to run, so the next time it happens remove the flame arrestor and see if the injectors are spraying gas when it's cranking. My 95 doesn't have a port to check the fuel pressure. You can either...

Just to clarify the problem. When you turn the key is the starter turning the engine over (cranking) but the engine doesn't fire up? Or is the starter not turning the engine over when you turn the key?

If it cranks fine but doesn't start, check to see if the safety lanyard is working. ...

Not familiar with the setup on an 83, so I'm asking. Is the end of the prop shaft that attaches to the coupling tapered? I just removed all of the underwater hardware on my 95 and my shaft is tapered on both ends. The shaft is held in the coupling with a nylock hex nut, and the shaft is keyed (no...

Thanks for the update. I'm getting ready to do the same thing and was waiting for the result. My Maristar only has one speedometer and the pitot is always getting clogged with the debris in our lake.

I agree that it was most likely operator error (I'm being polite). Those guys remind me of one specific "crew" on our lake. When something goes wrong, it's almost always the same people....

I stopped watching after about 2 minutes....

I was just on Skidim this morning ordering an impeller (non LT1). Your part number search says that Mastercraft used "Some Jabsco pumps around 1995". You might want to see if your pump has a part number stamped on it and then contact Skidim for the correct impeller.

https:/...

I'm looking for a used coupling that fits a 1-1/8 inch tapered prop shaft. Bolt pattern doesn't matter and it doesn't need to be in perfect condition because I plan to hit it with a hammer.

...

I kept my 97 F150 as a second vehicle when I bought my 2017 F150. My wife has her van, so I could see myself dumping the old 97 and getting a Maverick as my commute to work vehicle (5 miles one way). I just wonder if we will every see gas prices under $3.00/gallon again....

Marksa1458
Thanks for posting the pictures and information. All of my connections are stainless and they have the quick release pins. I think that I'm going to try a rear support pole that has the plastic/nylon ends like the ones on your top, that way I wont' have the metal to metal contact...

100% Agree. Coworker just bought one and the looks remind me of the Explorer Sport. 2 rows of seating, AWD, and a short bed for things that you don't want to put in the cab.
Want to haul a load of mulch? Buy a utility trailer, everyone doesn't need to tow a boat.
...

My wife goes to bed first and calls Brody (80lb Lab-Shepherd mix) in with her. Dog plays dead when I try to move him.
Mom 1/2
Dog 1/2
Dad in the guest room....

Could you post some close up pictures of the connection points for the rear support pole, top and bottom. My bimini is from a MasterCraft but it was designed for another model (I purchased it used) and the rear poles rattle. I wouldn't mine changing the hardware to plastic or just use straps, but...

I need to start rolling the extra flap up before Spring because this isn't the first time that this has happened. They don't do any harm but they need to be gone in 2-3 weeks.

...