500 results in 0.8892 seconds.
-
New DSP software coming for 2023. Louder. Might be retrofittable. You didn't hear it from me.. -
What model? Sounds like typical actuator failure. Lenco housing is plastic and prone to flexing and ruining the internals. You should be able to get the new Gerie Marie actuator(s) if under warranty. Same internals but billet housing that is sealed better and less prone to failure.Leave a comment:
-
They get the XT convertible seat with Seadeck step in the middle of rear seat. Some other cool features I probably shouldn't talk about. It's nice that MC listens to it's customers. Good changes to all canvas....Leave a comment:
-
Sic! Tint that windshield!...Leave a comment:
-
ProTour Red Flake! Wait until you see X24 I built. Gold flake X24 sold quick tooLeave a comment:
-
Do you have attitude adjustment plate? If so what is the position of the plate when it's walking?Leave a comment:
-
These are the MC part numbers:
Head Unit 409921
Remote: 404281
Amazon link to the remote is cheaper than MC cost if you factor in shipping..Leave a comment:
-
I think this remote works with your upgraded deck:
https://www.amazon.com/Fusion-Entert.../dp/B01H0NU7EILeave a comment:
-
I've seen two around here. I have a deposit on one. Like the 11k towing capacity and easy to water test boats with. Lots of short trips, no long trips so it might make sense.Leave a comment:
-
Let us know anymore vibration? Alignment, prop, strut and driveshaft. Many moons ago we aligned a motor to a bent driveshaft but if vibrated from idle to WOTLeave a comment:
-
Yes they make good coversLeave a comment:
-
There is another layer to the XT24 bulletin that makes it more difficult than the XT23. It's regarding the Starboard hardtank vent.Leave a comment:
-
Check fluid level at the pump. Access the rams in the tower and make sure the fittings are tight and not leaking!Leave a comment:
-
Beautiful boat!...Leave a comment:
-
Did you use new harness with new pump? MC #501000. Was the ground hooked up on the regulator?Leave a comment:
Leave a comment: