96 Prostar width

[beretta5spd]

Hey guys... I potentially need to use a trailer from a 1986 Nautique 2001 to transport a 1996 Prostar 190. Can someone supply the distance Between fenders for the trailer? Bonus points if you supply the distance from the fender to the Boat as well with the vessel centered on the trailer.

Somewhere on this forum it was posted that someone tried to use a nautique trailer to move a prostar at one point and the prostar was wide enough it was on the fenders and needed gel coat work after.

Thanks for any help in advance

[BigGixxerFixxer]

I can try to get you some measurements tonight but I’m pretty sure Nautiques of that vintage are much narrower than our boats.



Sent from my iPhone using Tapatalk

[gwozhog]

I just measured mine this weekend. My 205v measures 96”

[Shaun R]

205v was wider than a 190. Just walk it on the trailer and take it slow, you can make it work in a pinch.

[MIskiboat]

Take fenders off nautique trailer? How far are you going?

[Tsumi]

Beam is 85" wide. Hull is probably a bit narrower where the fenders are at, but likely not by much.

[BigGixxerFixxer]

Got some measurements:
78” between the fenders.
2 inches of clearance at the narrowest point between fenders and hull.
1996 Sport Boat Trailers tandem axle.



Sent from my iPhone using Tapatalk

[beretta5spd]

Thanks so much gixxerfixxer and all the other replies! That's a huge help

Got some measurements:
78” between the fenders.
2 inches of clearance at the narrowest point between fenders and hull.
1996 Sport Boat Trailers tandem axle.



Sent from my iPhone using Tapatalk